B unscrew the black cap at the bottom of the clean solution tank.
Bissell little green instructions how to clean.
Disconnect the cleaning tool from the hose grip by pushing down on the button lock and pulling straight off.
Use only bissell cleaning products intended for use in this appliance.
Use only manufacturer s recommended attachments.
Fill the water tank with hot water.
Wait 3 5 min for the solution to go to work before cleaning with the spray trigger released gently scrub the stain with the brush attachment to lift away the stain apply downward pressure on the tool and slowly pull it toward you.
How to deep clean carpet and upholstery getting ready continued press power switch to on position.
Release the step 2 wash out the hose.
Starter bottle of formula.
All bissell little green machine devices are designed to use a combination of water and little green cleaning formula.
Do not use for any purpose other than described in this user s guide.
Read all instructions before using your little green warning.
Suction clean water from a bowl or faucet to clean the hose.
Connect to a properly grounded outlet only.
The front of the tough stain tool deep stain tool and 3 in 1 stair tool can be removed for easy cleaning.
C add bissell little green formula to the formula fill line 8 oz on the clean solution tank.
Set the machine to high traffic and the handle to the recline position 1 x research source move the machine back and forth on the carpet while pressing the spray trigger for fifteen seconds.
See the cleaning fluid section of this guide.
If you aren t sure which tank is which the clean water tank is always the one with the water and formula lines on it.
Step 1 flush the machine after each use.
Simply push the button at the top of the tool and slide the front of the tool off the base.
The tools can be rinsed under clean water.
Your little green is shipped with an 8 oz.
Cleaning with the bissell little green proheat machine step 1 spray cleaning solution from the spray trigger onto the area to be cleaned holding it about 1 inch from the surface.
Lift the water solution tank off the base unit and then fill it to the marked water line with hot tap water.
To reduce the risk of fire electric shock or injury.
